|
|
|
|
|
Some members look on as Jim Vasi sets up for the demo before the meeting starts |
Kurt Hertzog does some Highland Hardware browsing before the meeting |
At 7:30, President Kurt Hertzog gets the meeting started |
After a short business meeting, Kurt Hertzog leads off the show and tell |
|
|
|
|
|
Steve Imerese shows one of his few non-segmented turning |
|
'Tis the season for wine stoppers as Bill Vail shows |
Gordy Fritz has been making tools and turnings |
|
|
|
|
|
Back from New Zealand, Jake Debski has been busy turning |
Bill Collins has two new bowls to show |
After the show and tell drawings, Turners 1 President Jim Vasi gets his demonstration started with handouts |
Having taught woodshop for over thirty years, Jim begins with some explanations at the board |
|
|
|
|
|
He shows the Hilburger jig used for cutting the segments of his bowls |
With the segments planned and cut, they are dry fitted to check for accuracy |
Content that all is well, Jim begins gluing up one of the rings |
With the segments glued, the ring is squeezed using a screw clamp |
|
Go to page 2 |
|
|
| |
|
|
|
Photos by Kurt Hertzog |
|
|
|
